![]() Place the cam sprocket, with its chain mounted over it, in position on the front of the truck and pull up with the three bolts that hold it to the camshaft.Arrange the camshaft gear in such a way that the timing marks will line up between the shaft centers and the camshaft locating dowel will enter the dowel hole in the cam sprocket. Without disturbing the position of the engine, mount the new crankshaft gear on the shaft, and mount the chain over the camshaft gear.3: Remove the camshaft gear and timing chainĪ gear puller will be required to remove the crankshaft gear. 2: Remove the camshaft gear retaining boltsįig. The chain comes off with the camshaft gear.įig. This gear is a light press fit on the camshaft and will come off easily. Take out the bolts that hold the camshaft gear to the camshaft.On 7.4L engines tool J-41371 or its equivalent puller must be used to remove the reluctor ring. ![]() On 1996-98 vehicles remove the crankshaft position sensor reluctor ring, if equipped.1: Crank the engine until the timing marks on both sprockets are in line Crank the engine until the timing marks on both sprockets are nearest each other and in line between the shaft centers.įig.This will allow access to the timing chain. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |